Yard VacuumChipper/Shredder/Vacuum/HoseModel Number24A-060F063 OPERATOR’S MANUALIMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYTROY-BILT LLC P
10Nozzle Height AdjustmentThe nozzle can be adjusted to any six positions, ranging from 5/8” to 4 1/8” ground clearance. The nozzle height has to be a
11MaintenanceEngineRefer to the separate engine manual for all engine maintenance instructions.• Check engine oil level before each use as instructed
12Figure 14• Remove lock nut that secures flail screen to the lower housing. The flail screen does not have to be removed. Refer to Figure 11.• Remove
13SECTION 6: TROUBLESHOOTINGNOTE: For repairs beyond the minor adjustments listed above, contact your nearest authorized service dealer. Problem Caus
14Model 24A-060F063 1234567894711121314151617181920211123242526222728292430313233343536373839411404142434444546474850514952535431495556
15Model 24A-060F063Ref. No.Part No. Part Description1. 720-0295 Foam Grip2. 749-0438D Upper Handle3. 720-0279 Knob4. 712-3004A Flange Lock Nut 5/16-18
16Model 24A-060F0631234567891011121314151617181920211722232425262728293031323334353615373839404142434458555659604748495051524253544446453957
17Model 24A-060F063Ref. No.Part No. Part Description1. 664-0095 Bag Assembly2. 681-0154 Screen Assembly3. 710-1054 Hex Screw 5/16-24 x 1.0 4. 781-0490
2TABLE OF CONTENTSContent PageImportant Safe Operation Practices...3Assembling Your Ya
MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used
3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: This symbol points out important safety instructions which, if not followed, could endanger th
4i. Never store the machine or fuel container inside where there is an open flame, spark, or pilot light (e.g. furnace, water heater, space heater, cl
5WARNING - YOUR RESPONSIBILITY: Restrict the use of this power machine to persons who read, understand and follow the warnings and instructions in thi
6Attaching The Handle• Unfold the upper handle until it aligns with the lower handle.• Secure the two handles by tightening the wing nuts (carriage bo
7Attaching The Blower Chute (If Equipped) • Grasp blower chute with one hand and slide locking rod on mounting bracket with other hand toward engine.
8Chipper ChuteAllow twigs and small branches up to 1 1/2” in diameter to be fed into the impeller for chipping. Blower Chute (If Equipped) When attach
9• Hold bag handle and bag clip while emptying the contents.• Compress bag opening and fold inner flap over opening.• Fold outer flap over inner flap
Comments to this Manuals