Troy-Bilt Polar Blast 3310 Snow Thrower User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
Assembly
IMPORTANT: Two replacement auger shear pins are included
with this manual (or stowed in the plastic handle panel). Refer to
the Maintenance section for more information regarding shear
pin replacement.
NOTE: All references in this manual to the left or right side of the
snow thrower is from the operating position only. Exceptions, if
any, will be specified.
IMPORTANT: This unit is shipped with the engine full of oil.
After assembly, refer to the separate Engine Owner’s Manual
included with this unit for fuel and oil fill-up details.
NOTE: Specifications are subject to change without notification
or obligation. Images may not reflect your exact model and are
for reference purposes only.
Handle
1. Remove any packaging material from the upper handle.
2. Remove the lower plastic wing nut, belleville washer and
carriage bolt from each side of the upper handle; then raise
the upper handle assembly until it snaps over the lower
handle. See .
Figure 3-1
3. Looking beneath the handle panel, check that all of the
cables (steering, auger, shift, and drive) are properly routed
and not pinched or kinked. Make certain the springs at the
lower end of the auger and drive cables are securely hooked
into their respective actuator bracket. See Figure 3-9.
4. Secure the upper handle and lower handle with the two
wing nuts, belleville washers, and carriage bolts removed
earlier. Tighten the two wing nuts already installed in the
upper holes to firmly secure the upper handle and support
tubes. See .
Figure 3-2
Chute Assembly
1. Loosen, but do not remove, the chute crank bracket in
order to attached the chute assembly. See .
Chute Crank
Bracket
Figure 3-3
Contents of Carton
One Snow Thrower Two Replacement Auger Shear Pins One Chute Assembly
One Snow Thrower Operator’s
Manual
One Engine Operators Manual One Product Registration Card
Assembly & Set-Up
3
7
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Comments to this Manuals

No comments