Troy-Bilt 2690 User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
Oil Fill
Engine oil level can be checked and oil added through the oil fill.
Oil Drain
Engine oil can be drained through the oil drain.
Muffler
Engine exhaust exists the engine via the muffler.
WARNING! Do not touch the muffler while the
engine is hot or running. The muffler is hot and can
cause a severe burn.
Electric Starter Outlet
Requires the use of a three-prong outdoor extension cord and a
120V power source/wall outlet.
NOTE: The electric starter is mounted to the plastic shroud and is
shown in Fig. 4-1 attached to the engine for easier reference.
Electric Starter Button
Pressing the electric starter button engages the engine’s electric
starter when plugged into a 120V power source.
Gas Cap
Unthread the gas cap to add gasoline to the fuel tank.
Primer
Pressing the primer forces fuel directly into the
engines carburetor to aid in cold-weather starting.
Throttle Control
The throttle control is located on the engine. It regulates the
speed of the engine and will shut off the engine when pushed
into the stop position.
Choke Control
The choke control is found on the rear fo
the engine and is activated by rotating the
knob clockwise. Activating the choke control
closes the choke plate on the carburetor and
aids in starting the engine.
Ignition Key
The safety ignition key must be fully inserted
and snapped in place before the engine will
start. Remove the ignition key to prevent any
unauthorized use of the equipment.
NOTE: Do NOT attempt to turn the key.
RUN
MARCHE
CHOKE
VOLET DE
PA RT
14 se c t i O n 4— cO n t r O l s a n d fe a t u r e s
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Comments to this Manuals

No comments