Troy-bilt STORM TRACKER 2690XP User Manual download pdf (Page 20)

Unhook the idler spring from the hex bolt on the auger 



Lift the auger belt from the auger pulley, and slip belt 7.

between the support bracket and the auger pulley. See

Fig. 7-5.

Replace auger drive belt by following instructions in 8.

reverse order.



Drive Belt



as follows:

To prevent spillage, remove all fuel from tank by running 

engine until it stops. Do not attempt to pour fuel from the

engine.

Remove the plastic belt cover on the front of the engine by 2.



Carefully pivot the snow thrower up and forward so that it 3.

rests on the auger housing.

Remove the frame cover from the underside of the snow 

thrower by removing self-tapping screws which secure it.

Ref. Fig. 7-2.

To remove the belt from the pulleys proceed as follows:5.

Roll the auger belt off the engine pulley.a.

b.

Lift the drive belt off engine pulley.c.

Back out the stop bolt until the support bracket rests on 

















Bracket







 se c t i O n 7 — se r v i c e

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

No comments

Troy-bilt STORM TRACKER 2690XP User Manual Page 20