Troy-bilt TB90BC User Manual download pdf (Page 8)

ASSEMBLY INSTRUCTIONS

6. While holding the unit in the operating position

(Fig. 3), position the J-handle to the location

that provides you the best grip.

7. Tighten the clamp screws evenly, until the J-handle

is secure.

INSTALLING THE HARNESS

WARNING: Always use the shoulder harness

when using the cutting blade to avoid serious

personal injury.

1. Push the strap through the center of the buckle.

2. Pull the strap over the cross bar and down through

the slot in the buckle (Fig. 4).

Decal

Fig. 1

Fig. 4

Fig. 6

Fig. 5

Fig. 2

Fig. 3

3. Put the harness on over head and onto shoulder.

Snap it on to the support fitting (Fig. 5).

Support Fitting

4. Adjust length to fit the operator’s size. Pull tab to

lengthen, pull strap to shorten (Fig 6).

INSTALLING AND ADJUSTING THE J-HANDLE

1. Place the J-handle between the top and middle

clamp pieces (Fig. 1).

2. While holding the three pieces together, install the

four (4) screws through the top clamp and into

middle clamp.

NOTE: The holes in the top and middle clamp will line up

only when assembled correctly.

3. Place the clamps and J-handle the over the shaft

housing and onto the bottom clamp.

4. Hold each hex nut in the bottom clamp recess with a

finger. Start screws with a large Phillips screwdriver.

Do not tighten until you make the handle adjustment.

5. Slide the J-handle in or out until the arrow/white line

on the decal touches the clamp assembly (Fig. 2).

(4) Screws

Top Clamp

J-Handle

Middle Clamp

Bottom Clamp

Nuts

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 83 84

Comments to this Manuals

No comments

Troy-bilt TB90BC User Manual Page 8

Comments to this Manuals

Related products and manuals for Gardening equipment Troy-bilt TB90BC