Troy-bilt TB525CS User Manual download pdf (Page 5)

ASSEMBLY INSTRUCTIONS

ADJUSTING THE D-HANDLE

1. Loosen the clamp screws on the handle just enough to

move it.

2. While holding the unit in the operating position (Fig. 6),

move the D-handle to the location that provides you the

best grip .

3. Tighten the clamp screws evenly, until the D-handle is secure.

TB575SS

1. Slide the cutting attachment shield into the shield mount on

the cutting attachment. Align the screw holes in the shield

with the holes in the cutting attachment (Fig. 4).

Fig. 4

INSTALL CUTTING ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield

on your unit is not installed. Use only the instructions that apply

to the type of shaft and shield that your unit is equipped with.

TB525CS

1. Place the cutting attachment shield onto the shaft housing

above the clamp assembly (Fig. 1).

2. Push the cutting attachment shield down to the top of the

cutting attachment assembly and then rotate the cutting

attachment shield until the screw holes align and the guard

fits into the recessed pocket (Fig. 2).

3. Install the screws with a Phillips screwdriver (Fig. 3).

(4) Screws

D-Handle

Bottom

Clamp

Fig. 6

Minimum

6 inches

(15.24 cm)

Fig. 1

Fig. 2

Shaft Housing

Fig. 3

(4) Screws

Clamp

Assembly

Cutting

Attachment

Assembly

Cutting Attachment

Shield

Recessed

Pocket

2. Place a hex lock nut into one of the three recessed holes on

the top of the cutting attachment shield (Fig 5).

3. Install a screw into the hole from the bottom of the cutting

attachment shield and screw it into the nut installed in step

2 (Fig. 5). Do not tighten.

4. Repeat steps 2 and 3 until all three screws have been

started, then tighten securely.

WARNING: To prevent serious personal injury,

never operate the trimmer without the cutting

attachment shield in place.

Fig. 5

1 2 3 4 5 6 7 8 9 10 ... 63 64

Comments to this Manuals

No comments

Troy-bilt TB525CS User Manual Page 5

Comments to this Manuals

Related products and manuals for Gardening equipment Troy-bilt TB525CS