Troy-Bilt TB210 User Manual download pdf (Page 12)

12 Section 3 — ASSembly & Set-Up

Adjustments

Cutting Height

There is a cutting height adjustment lever located above the

front and rear right wheel.

1. Pull the height adjustment lever towards wheel (unit will

tend to fall when lever is moved outward).

2. Move lever to desired position for a change in cutting

height. See Fig. 3-10.

3. Release lever towards deck.

IMPORTANT: Both the front and rear wheels must be

placed in the same relative position. For rough or uneven

lawns, move the height adjustment levers to a higher

position. This will stop scalping of grass.

Lower

Higher

Handle Pitch

For convenience of operation, you may adjust the pitch of the

handle as follows:

1. Remove wing nuts and carriage bolts from handle. See Fig.

3-11.

2. Position the handle in one of the three positions that is

most comfortable. See Fig. 3-11 inset.

3. Secure into position with wing nuts and carriage bolts

removed earlier.

Set-Up

Gas and Oil Fill-Up

Refer to the separate engine owner’s manual for additional

engine information.

1. Add oil provided before starting unit for the first time out

of the box.

2. Service the engine with gasoline as instructed in the

separate engine owner’s manual.

WARNING: Use extreme care when handling

gasoline. Gasoline is extremely flammable and the

vapors are explosive. Never fuel the machine

indoors or while the engine is hot or running.

Extinguish cigarettes, cigars, pipes and other

sources of ignition.

3. Charge battery as instructed in the Service section of this

manual (Electric Start Units).

Figure 3-11

Figure 3-10

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Comments to this Manuals

No comments

Troy-Bilt TB210 User Manual Page 12

Comments to this Manuals

Related products and manuals for Unknown Troy-Bilt TB210