Troy-bilt Polar Blast 10530 User Manual download pdf (Page 15)

Figure 18

Auger Belt

• Remove the cotter pin and washer from the ferrule

in order to disconnect the auger idler rod from the

brake bracket assembly. See Figure 19.

• Slip the auger control belt (the front belt) off the

engine pulley.

Figure 19

• Pull the brake bracket assembly towards the cable

guide roller and unhook the auger cable “Z” fitting.

• Remove the upper bolts and lock washers which

attach the auger housing assembly to the frame

assembly using a 9/16” wrench. See Figure 18.

• Separate the auger housing from the frame

assembly by tilting the housing forward and pulling

up the handles.

• Using a 1/2” wrench, remove the hex screw and

bell washer from the center of the pulley on the

auger housing. Lift the brake bracket assembly out

of the pulley groove and remove the pulley. Be

careful not to lose the key. See Figure 20.

• Remove and replace auger belt inside belt keepers.

• Reassemble pulley to auger housing with hex

screw and bell washer (cupped side toward the

pulley). Make sure key is in place on shaft and

brake puck is seated in the pulley groove.

Figure 20

• Reassemble the belt cover and chute directional

control.

Proper Adjustment: With the auger clutch lever in the

disengaged position the top surface of the new belt

should be even with the outside diameter of the pulley.

• To adjust, disconnect ferrule from brake bracket

assembly and thread ferrule in (towards idler) to

increase tension on belt, and out to decrease tension.

NOTE: The brake puck must always be firmly seated in

the pulley groove when the auger control is in the

disengaged position.

Drive Belt

• Unhook the extension spring from the belt cover

plate. See Figure 21.

• Remove drive belt from the engine pulley and

bottom drive pulley. Refer to Figure 21.

• Replace belt and reassemble in reverse order.

• Reassemble the two halves of the unit hooking the

lower portion of the auger housing over the

stationary shoulder bolts in the frame assembly.

Figure 21

Shoulder Bolt

Engine Pulley

Ferrule

Engine

Pulley

Auger Idler

Rod

Auger Control

Belt

Brake Bracket

Assembly

Z Fitting

Cable Roller

Guide

Brake Bracket Assembly

Auger Belt

Hex Screw &

Bell Washer

Belt Keepers

Auger Pulley

Idler Pulley

Drive Belt

Extension Spring

Belt Cover

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments

Troy-bilt Polar Blast 10530 User Manual Page 15

Comments to this Manuals

Related products and manuals for Cars Troy-bilt Polar Blast 10530