Troy-bilt 7524 User Manual download pdf (Page 7)

Figure 7

Shift Lever

The shift lever is located in the center of the handle

panel and is used to determine ground speed and

direction of travel. It can be moved into any of eight

positions. See Figure 7.

IMPORTANT:

Always release traction the control before

changing speeds.

Forward

Your snow thrower has six forward (F) speeds.

Position number one (1) is the slowest and position

number six (6) is the fastest.

Reverse

Your snow thrower has two reverse (R) speeds. R1 is

the slower, while R2 is the faster of the two.

Traction Control / Auger Control Lock

The traction control is located on the right handle.

Squeeze the traction control to engage the wheel drive.

Release to stop. See Figure 7.

This same lever also locks the auger control lock, so

you can operate the chute crank without interrupting the

snow throwing process. If the auger control is engaged

simultaneously with the traction control, the operator

can release the auger control (on the left handle) and

the augers will remain engaged. Release the traction

control to stop both the augers and wheel drive (the

auger control must also be released).

IMPORTANT:

ALWAYS release the traction control

before moving the shift lever. Failure to do so will result

in premature wear to the drive system’s friction wheel.

Auger Control

The auger control is located on the left handle.

Squeeze the auger control to engage the augers.

Release to stop the snow throwing action. The traction

control must also be released in order to stop the auger.

IMPORTANT:

Refer to Auger Control Test on page 9 prior to

operating your snow thrower. Read and follow all

instructions carefully and perform all adjustments to

verify your snow thrower is operating safely and

properly.

Chute Directional Control

The chute directional control is located on left hand side

of the snow thrower.To change the direction which

snow is thrown, rotate chute directional control as

follows:

• Clockwise to discharge to the left.

• Counterclockwise to discharge to the right.

Chute Clean-out Tool

WARNING: Never use your hand to clear a

clogged discharge chute. Shut off engine and

remain behind handles until all moving parts

have stopped before unclogging.

This item is fastened with a cable tie to the rear of

the Auger Housing at the factory. Cut the cable tie

before operating the snow thrower.

The chute clean-out tool (see Figure 7) is designed to

clear a clogged discharge chute. Refer to page 10 for

detailed instructions on how to properly use the chute

clean-out tool.

Fuel Tank

Auger

Skid Shoe

Switch

Box

Electric

Starter

Button

Recoil

Starter

Handle

Primer

Choke

Safety Ignition Key

Throttle Control

Shift Lever

Traction Control /

Headlight

Discharge

Auger Control

Chute Tilt Control

Chute Directional Control

Auger Control Lock

Chute

Clean-out Tool

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Troy-bilt 7524 User Manual Page 7

Comments to this Manuals

Related products and manuals for Cars Troy-bilt 7524