Troy-Bilt TB210 User Manual download pdf (Page 10)

10 se c t i O n 3 — as s e M b l y & se t -up

The rope guide is attached to the right side of the upper 

handle. Loosen the wing knob which secures the rope



a.

Slowly pull starter rope handle from engine and slip b.



Tighten rope guide wing knob.c.

Use cable tie(s) to secure cable(s) to lower handle.d.

Grass Catcher

Follow steps below to assemble the grass catcher (if 

needed). Make certain bag is turned right side out before

assembling (warning label will be on the outside).

a.

at the bottom.

Remove the T-bolts from the handle brackets as shown in 2.

Fig. 3-3.

Follow the steps below to complete handle assembly:3.

a.

handle (shown in Fig. 3-3 deck cutaway) line up with



NOTE: When pulling upward on handle, make sure to not

pull handle all the way out.

Insert the T-bolts removed earlier through the b.

handle brackets and lower handle and tighten



Reattach wing nuts and carriage bolts removed c.

earlier into lower holes of handle as shown in Fig.

3-5.









1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

No comments

Troy-Bilt TB210 User Manual Page 10