Troy-bilt 650 User Manual

TROY-BILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019Printed In USAOperatOr’s ManualSafe Operation Practices • Set-Up • Operation • Maintenance •

Figure 4-1NOTE: This Operator’s Manual covers various models of tillers and the machine illustrated may vary slightly from your tiller.Engine Controls

Starting the EnginePre-Start ChecklistWith the spark plug wire disconnected from the spark plug, perform the following checks and services before each

To Engage Drive & TinesFor forward motion of the wheels and power to the tines pull the Forward Clutch Bail up against the handlebar. Release the

Clearing the TinesThe tines have a self-clearing action which eliminates most tangling of debris in the tines. However, occasionally dry grass, string

Suggested Tilling PatternsWhen preparing a seedbed, go over the same path twice in the first row, then overlap one-half the tiller width on the rest o

Terrace GardeningTo create a terrace, start at the top of the slope and work down. Go back and forth across the first row as shown in Fig. 5-8. Each s

WARNING! Before inspecting, cleaning or servicing the machine, shut off the engine, wait for all moving parts to come to a complete stop, disconnect t

Transmission Gear OilCheck the transmission gear oil after every 30 hours of operation or whenever you notice any oil leak. Operating the tiller when

AdjustmentsForward Drive BeltIt is important to maintain the correct tension on the forward drive belt. A loose belt will cause the tines and wheels t

Prevent the inner jam nut from turning and tighten the outer jam nut against the bracket. Prevent the outer jam nut from turning and tighten the inner

Customer SupportPlease do NOT return the machine to the retailer or dealer without first contacting our Customer Support Department.If you have diffic

Belt ReplacementIf the drive belt needs to be replaced, see your local authorized dealer or refer to the Replacement Parts Section for ordering inform

Problem Cause RemedyEngine does not start Spark plug wire disconnected.Engine Throttle Control Lever incorrectly set.Fuel tank empty.Stale gasoline.Di

Component Part Number and Description754-04091 Reverse Drive Belt754-04090 Forward Drive Belt746-04208 Forward Drive Cable746-04058 Reverse Drive

Notes1023

MANUFACTURER’S LIMITED WARRANTY FORGDOC-100023 REV. CThe limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise pu

Important Safe Operation Practices23TrainingRead, understand, and follow all instructions on the machine and in the manual(s) before attempting to ass

4 sectiOn 2 — iMpOrtant safe OperatiOn practicesAfter striking a foreign object, stop the engine, disconnect the spark plug wire and ground against th

5sectiOn 2 — iMpOrtant safe OperatiOn practicesIf the fuel tank has to be drained, do this outdoors.Observe proper disposal laws and regulations for g

WARNING! To prevent personal injury or property damage, do not start the engine until all assembly steps are complete and you have read and understand

Using two ⁄”-18 x 1-⁄” screws, ⁄” split lock washers and ⁄”-18 hex nuts, loosely attach the handlebar support using the upper holes. Tighte

Forward Clutch CableCarefully unwrap the forward clutch cable from its shipping position and slide the thin cable wire into the slot in the cable brac

Reverse Clutch CableUnwrap the reverse clutch cable from its shipping position and route it up to the handlebar. See Fig. 3-7. Be sure that the cable