Troy-bilt CSV206 User Manual download pdf (Page 4)

2. Before starting the machine, make sure the chipper

chute, feed intake, and cutting chamber are empty and

free of all debris.

3. Thoroughly inspect all material to be shredded and

remove any metal, rocks, bottles, cans, or other foreign

objects which could cause personal injury or damage to

the machine.

4. If the impeller strikes a foreign object or and/or if your

machine should make an unusual noise or vibration, shut

the engine off immediately . Allow the impeller to stop;

disconnect the spark plug wire, ground it against the

engine and perform the following steps:

a. Inspect for damage.

b. Repair or replace any damaged parts.

c. Check for any loose parts and tighten to assure

continued safe operation.

4. Do not allow an accumulation of processed material to

build up in the discharge area. This can prevent proper

discharge and result in kickback of material through the

feed opening.

5. Do not attempt to shred or chip material larger than

specified on the machine or in this manual. Personal

injury or machine damage could result.

6. Never attempt to unclog either the feed intake or

discharge opening while the engine is running. Shut the

engine off, wait until all moving parts have stopped,

disconnect the spark plug wire and ground it against the

engine before clearing debris.

7. Never operate without vacuum bag and discharge chute

properly attached to the machine. Never empty or

change vacuum bag while the engine is running.

Zippered end of vacuum bag must be kept closed at all

times during operation.

8. Never operate without either the inlet nozzle or optional

hose attachment properly attached to the machine.

Never attempt to attach or change either attachment

while the engine is running.

9. Keep all guards, deflectors and safety devices in place

and operating properly.

10. Keep your face and body back and to the side of the

chipper chute while feeding material into the machine to

avoid accidental kickback injuries.

11. Never operate this machine without good visibility or

light. Always be sure of your footing and keep a firm hold

on the handles.

12. Do not operate this machine on a gravel surface.

13. Do not operate this machine while under the influence of

alcohol or drugs.

14. Muffler and engine become hot and can cause a burn. Do

not touch.

15. Never pick up or carry machine while the engine is

running.

Maintenance & Storage

1. Never tamper with safety devices. Check their proper

operation regularly.

2. Check bolts and screws for proper tightness at frequent

intervals to keep the machine in safe working condition.

Also, visually inspect machine for any damage and

repair, if needed.

3. Before cleaning, repairing, or inspecting, stop the engine

and make certain the impeller and all moving parts have

stopped. Disconnect the spark plug wire and ground it

against the engine to prevent unintended starting.

4. Do not change the engine governor settings or

overspeed the engine. The governor controls the

maximum safe operating speed of the engine.

5. Maintain or replace safety and instruction labels, as

necessary.

6. Follow this manual for safe loading, unloading,

transporting, and storage of this machine.

7. Never store the machine or fuel container inside where

there is an open flame, spark or pilot light such as a water

heater, furnace, clothes dryer, etc.

8. Always refer to the operator’s manual for proper

instructions on off-season storage.

9. If the fuel tank has to be drained, do this outdoors.

10. Observe proper disposal laws and regulations for gas,

oil, etc. to protect the environment.

Your Responsibility

Restrict the use of this power machine to persons who

read, understand and follow the warnings and

instructions in this manual and on the machine.

NOTE: Not all safety labels shown may apply to your

chipper shredder vacuum.

1 2 3 4 5 6 7 8 9 ... 13 14

Comments to this Manuals

No comments

Troy-bilt CSV206 User Manual Page 4

Comments to this Manuals

Related products and manuals for Tools Troy-bilt CSV206