Troy-Bilt 30245 User Manual download pdf (Page 6)

ASSEMBLY

Your generator requires some assembly and is ready for

use after it has been properly serviced with the

recommended oil and fuel.

If you have any problems with the assembly of your

generator, please call the generator helpline at

1-888-611-6708. If calling for assistance, please have the

model, revision, and serial number from the data tag available.

See “Know Your Generator” for data tag location.

Unpack the Generator

1. Set the carton on a rigid flat surface.

2. Remove everything from carton except generator.

3. Open carton completely by cutting each corner from

top to bottom.

4. Leave generator on carton to install wheel kit.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.

You will need the following tools to install these

components:

• 13mm wrench

• Socket wrench with a 13mm socket

• Pliers

• Safety glasses

Refer to Figure 1 and install the wheel kit as follows:

1. Tip generator so that engine end is up.

2. Slide axle through both mounting brackets.

3. Place a wheel on each side as shown in Figure 1A.

4. Place a washer on axle and then place an e-ring in axle

groove.

Support Leg

Axle

Flat Washer

Wheel

E-Ring

Figure 1 — Install Wheel Kit

Axle

Wheel

Section

Assembly

Hex Nut

Capscrew

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Troy-Bilt 30245 User Manual Page 6