Troy-bilt 106 User Manual

IMPORTANT: Read safety rules and instructions carefully before operating equipment.TROY-BILT LLC., P.O. BOX 361131, CLEVELAND, OHIO 44136-001920"

10SECTION 6: MAKING ADJUSTMENTSWARNING: Do not at any time make anyadjustment to your lawn mower without firststopping the engine and disconnecting t

11Figure 10WARNING: Be sure to disconnect andground the spark plug wire before performingany repairs or maintenance.NOTE: When tipping the unit, empty

12performance and flooding usually indicates that the air cleaner should be serviced. To service the air cleaner, refer to the engine manual.• The spa

13777S30118777S30108777D06000ON SIDE DISCHARGE DOOR777S30143TO REDUCE THE RISK OF INJURY,DO NOTOPERATE UNLESS THIS GUARD IS INIT'S PROPER PLACE.

14SECTION 10: PARTS LIST MODEL 10623456789101112138151617181920212223242526272829303233343336373839402721261922232425414243442035464645381

15Model 106Ref. No. Part No. Description1. 647-04014 Control Handle Assembly2. 710-1270 Oval C-Sunk Screw3. 712-0324 Hex Lock Nut4. 746-0883 Control H

MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices... 3Slope Gauge...

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: This symbol points out important safety instructions which, if not followed, could endangerthe

4other safety protective devices in place and working. Never operate mower with damaged safety devices. Failure to do so, can result in personal injur

5meet the original equipment specifications may lead to improper performance and compromise safety!” 4. Mower blades are sharp and can cut. Wrap the

6SECTION 2: SLOPE GAUGE15°SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREEA POWER POLEA CORNER OF A BUILDINGOR A FENCE POSTFOLD ON DOTTED LINE, REPRESE

7SECTION 3: ASSEMBLING YOUR LAWN MOWERTo Remove Unit From Carton• Remove staples, break glue on top flaps, or cut tape at carton end and peel along t

8• With the spark plug wire disconnected and grounded, hold the blade control handle against the upper handle, and pull the starter rope out of the en

9SECTION 5: OPERATING YOUR LAWN MOWERWARNING: Keep hands and feet awayfrom the chute area on cutting deck. Theblade will be rotating whenever the eng